Installation guide

KINO-6612 Mini-ITX Motherboard
Page 91
The KINO-6612 must be installed in a chassis with ventilation holes on the sides allowing
airflow to travel through the heat sink surface. In a system with an individual power supply
unit, the cooling fan of a power supply can also help generate airflow through the board
surface.
NOTE:
IEI has a wide range of backplanes available. Please contact your
KINO-6612 vendor, reseller or an IEI sales representative at
[e-mail] or visit the IEI website (328H329Hhttp://www.ieiworld.com.tw)
to find out more about the available chassis.
5.6.2 Motherboard Installation
To install the KINO-6612 motherboard into the chassis please refer to the reference
material that came with the chassis.
5.7 Internal Peripheral Device Connections
5.7.1 Peripheral Device Cables
The cables listed in 850H852HTable 5-7 are shipped with the KINO-6612.
Quantity
Type
1 ATA 66/100 flat cable
1 I/O Shield
2 SATA drive cable
1 SATA drive power cable
1 Dual RS-232 cable
Table 5-7: IEI Provided Cables