Installation guide

KINO-6612 Mini-ITX Motherboard
Page 114

Legacy Mode
The PCI IDE mode will be the same as the IDE
mode

Native Mode DEFAULT
The PCI IDE mode will be the native mode
 Onboard PCI S-ATA Controller
The Onboard PCI S-ATA Controller option sets the onboard SATA controller. If the RAID
function is used (see Appendix E) this option must be set in the RAID mode.

Disabled DEFAULT
The onboard PCI SATA controller is disabled

Native Mode
The SATA controller is set as an IDE device with ID
at 0181h

Raid Mode
The SATA controller is set as a RAID device with ID
at 0181h
 IDE Master and IDE Slave
When entering setup, BIOS auto detects the presence of IDE devices. BIOS displays the
status of the auto detected IDE devices. The following IDE devices are detected and are
shown in the IDE Configuration menu:
 Primary IDE Master
 Primary IDE Slave
 Secondary IDE Master
 Secondary IDE Slave
The IDE Configuration menu (
876H878HBIOS Menu 4) allows changes to the configurations for the
IDE devices installed in the system. If an IDE device is detected, and one of the above
listed four BIOS configuration options are selected, the IDE configuration options shown in
Section
877H879H6.3.2.1 appear.