Installation guide

KINO-6612 Mini-ITX Motherboard
Page 28
2.6.3.2 Super I/O Infrared
The onboard Super I/O supports the following infrared specifications:
 IrDA version 1.0 SIR protocol with a maximum baud rate up to 115.2Kbps
 Supports SHARP ASK-IR protocol with maximum baud rate of 57,600bps
The infrared controller on the super I/O is interfaced through the board-to-board
connectors on the KINO-6612 to an infrared pin-header on a backplane.
2.6.3.3 Super I/O Hardware Monitor Functions
The Super I/O Hardware Monitor monitors internal voltages, system temperature and the
cooling fan speed. All the monitored environmental parameters can be read from the BIOS
Hardware Health Configuration menu.
2.6.3.4 Super I/O Fan Speed and Fan Control
The super I/O can both monitor and control the fan speed. The super I/O is interfaced to
the fan on the backplane through the board-to-board connectors.
2.6.3.5 Super I/O UART
Two 16550 UART controllers on the super I/O are interfaced to one external RS-232 serial
port connector and one onboard RS-232/422/485 pin-header connector. Some of the
features of the UART are listed below:
 16-byte send/receive FIFO
 MIDI compatible
 Fully programmable serial interface characteristics
o 5, 6, 7 or 8 bit characters
o Even, odd or no parity bit generation detection
o 1, 1.5 or 2 bits stop generation
 Internal diagnostic capabilities
 Maximum baud rate up to 921 kbps for 14.769 MHz and 1.5 Mbps for 24 MHz