Specifications

How to set up the projector and screen
n Using the invert and reverse functions makes the following setups possible.
Caution: When setting up the projector
l Do not place it in humid or dusty places, or places where the air is sooty or full of cigarette smoke. If the lens,
mirror, or other optical components become dirty, the picture will blur or darken, making viewing difficult.
l Do not expose to extreme heat or cold.
Operating temperature: 5°C to 40°C
Storage temperature: -20°C to 55°C
.. Do not tilt the projector more than 10”.
W Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes
out colours, making viewing difficult. Close the curtains and dim the lights when using the screen in a bright or
sunny room.
W The best picture will be obtained when the projector is at a 90 degree angle to the screen. Position the projector
and screen as shown.
Example of a standard setup
TOP VIEW
Lens centre
The projector lens should be
If the projector and screen are not centred properly,
centred in the middle of the screen.
the picture will be distorted, makino viewing difficult.
Example of a reversed image setup
0
0
SIDE VIEW
By placing a mirror (normal flat type) in front of the lens and using the reverse function, the image reflected from
the mirror can be projected onto the screen.
Rear projection with a rear projection screen is also possible when using the reverse function.
AUDIENCE SIDE
4---+
Mirror
Rear Projection
i...
90”
R
I I
The projector lens should be
centred in the middle of the screen.
If the projector and screen are not centred properly,
the picture will be distorted, making viewing difficult.