Service manual

No. Adjusting point Adjusting conditions Adjusting procedure
25
XV-Z10000
6 Video bright-
ness/contrast
adjustment
1. Select the following group
and subject.
Group: VIDEO1
Subject: AUTO
By selecting AUTO with the control SW or the button
on the remote control after inputting the signal, it is
automatically adjusted.
7 Video TINT
adjustment
1. Input split color bar signal.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO 1
Subject: TINT
1. Check the fixed value.
Fixed value: 120
8 NTSC color
saturation
adjustment
1. Input split color bar signal.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: N-COLOR
1. Check the fixed value.
Fixed value: 100
9 PAL color
saturation
adjustment
1. Input the PAL color bar.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: P-COLOR
1. Check the fixed value.
Fixed value: 100
11 Check and
readjustment of
white balance
1. Use the adjustment condi-
tions in the item 6.
Check that there is no deviation of white balance with
the monitor.
10 SECAM color
saturation
adjustment
1. Input the SECAM color bar.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: S-COLOR
1. Check the fixed value.
Fixed value: 90
12 Color-related
operation check
1. Receive the color bar. 1.Select L1 of the process mode LINE. Operation check
of Color and Tint.
13 Video-related
operation check
1. Receive the monoscope. 1.Select L2 of the process mode LINE. Check of Pic-
ture, Bright, and Sharpness.
14 Operation check
of RGB
1. Receive the RGB signal. 1.Select L4 of the process mode LINE. Check of Pic-
ture, Bright, Red, Blue, Clock, Phase, H-POS, V-POS.