User Manual

-26
Turning the Projector on
Connect the required external equipment to the
projector before carrying out the following proce-
dures.
Info
• The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
51 .
1 Plug the power cord into the wall
outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2 Press
on the projector or
on the remote control.
• The power indicator illuminates green.
• When the lamp turns on, the lamp indica-
tor illuminates green. After the lamp indi-
cator illuminates green, the projector is
ready to start operation.
Note
• The lamp indicator illuminates, indicating
the status of the lamp.
Green: The lamp is ready.
Blinking in green: The lamp is
warming up.
Red:
The lamp should be replaced.
• If the projector is put into the standby
mode and immediately turned on again,
the lamp indicator may take some time
to illuminate.
Info
• See page 30 for details about adjusting
the focus and the size of the projected
image.
• See “Using the Adjustment Feet” on page
31 for adjusting the projector angle and
“Variable Lens Shift Feature” on page 32
for adjusting the projected image position.
Image Projection
Lamp indicator
Power
indicator
ON button
INPUT button
ON button