Operating Instructions

ManualsBrandsSharper Image ManualsToys & GamesToy RC Speed Bumper Road Rage

1. Insert the white peg (located on

bottom of rider) into the hole on

the vehicle’s seat.

2. Gently press down until the

rider clicks into place.

There are bumpers located on the

sides of each vehicle (one on each

side). The object of the game is to

knock the opposing rider o of its

vehicle by making contact with one

of the two bumpers.

NOTE: Bumpers can also be

activated by walls and other objects.

RC ROAD RAGE SPEED BUMPERS

OPERATING INSTRUCTIONS

Each vehicle requires 3 “AAA” 1.5V batteries (not

included). Each remote control requires 2 “AAA” 1.5V

batteries (not included). When changing batteries, adult

supervision is required. Use alkaline batteries for best

performance.

Locate the battery compartment on the bottom of each

vehicle, and the handle of each remote. Loosen the

screws and remove the battery doors. Insert “AAA”

batteries while observing the correct polarity in each

compartment. Replace the battery doors and tighten the

screws.

ii iiii

Switch both car and remote buttons to “ON” position.

For best result use the car on hard surfaces such as

wood or tile.

iiiiii

Carefully remove items from package.

Reverse

Attaching Rider Ejecting Rider

Forward

Left Turn

Right Turn

Battery

Cover

SAFETY PRECAUTIONS

1-800-374-2744

FOR TECHNICAL SUPPORT,

PLEASE CALL

HOLE

SIDE BUMPER

Led Power

Indicator

On/O

Switch

On/O

Switch

The artwork and design of this manual are protected by US copyright law and

may not be reproduced, distributed, displaced, published or used for any

purpose without prior written permission. Altering, removing or reproducing

any of the trademark or copyright notices on this package is not permitted.

Distributed by MerchSource, LLC, Irvine, CA 92618.

Model NO.: 1009537 Printed in China

• Do not operate during thunderstorms or rain.

• Avoid water, sand and snow when operating car.

• Do not submerge car or controller in water.

• Never operate your car on the street or highway.

• Never operate your car in a conﬁned or crowded area, and do

not use people or animals as obstacles.

• Do not run your car into furniture, objects or hard surface, as

this will cause damage to both the objects and your car.

• Keep ﬁngers, hair and loose clothing away from the tires. gears

and motor while the car is switched to “ON”.

• Do not leave car or transmitter near source of heat or under

direct sunlight for long periods of time.

• Do not leave car or transmitter outside overnight. Dampness is

harmful to interior components

• Remove all batteries when not in use to avoid accidental

operation

• Adult supervision is recommended when operating this car.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT

INFORMATION FOR FUTURE REFERENCE.

Due to continuous product improvements, the pictures on this manual may

dier slightly from the actual product.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment o and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit dierent from that to

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modiﬁcations to this unit not expressly approved by

the party responsible for compliance could void the user's authority to

operate the equipment.

BATTERY WARNING:

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or

rechargeable batteries.

• Insert batteries using the correct polarity.

Do not short-circuit the supply terminal.

• Remove batteries when not in use. Recycle or dispose of

exhausted batteries according to federal, state, and local

laws. Do not dispose of batteries in a ﬁre - they may leak

or explode.

• Only use manufacture speciﬁed battery(ies), charger(s)

and/or adapter, if applicable, speciﬁed by the manufacturer.

• Always use, replace, and recharge (if applicable) batteries

under adult supervision.

• Keep these instructions for future reference.