Use and Care Manual

16 English

This product comes with a remote control. The remote control functions are the

same as the control panel on the product.

The remote control requires 2 AAA batteries (included

but not installed). To install the batteries, remove the

cover located on the underside of the remote control.

If necessary, clean the battery contacts and also those

of the device prior to battery installation. Remove any

plastic protection from the batteries. On the inside of the

battery cover there is a + and a – sign indicating which

direction you should insert your batteries. Ensure the

batteries are installed correctly withregard to polarity.

Then replace the cover onto the bottom of the remote.

For battery replacement, always use the correct size and grade of battery for this

product.

REMOTE CONTROL

Note: Remove batteries from the remote control when not in use for an

extended period of time and always remove dead batteries immediately and

replace with fresh. Do not store dead batteries in remote.

Note: The remote requires a line-of-sight path to allow for the signal to be

received by the tower. Position the tower so the receiver lens (located at the

top of the product) is visible from the remote control.