Full Product Manual

7
English
- Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not
use gasoline, thinners, solvents, ammonias or other chemicals for
cleaning. Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid
risk of shock, all service and/or repairs must be done by contacting
(833.800.8669) or ([e-mail]).
- Protect against the growth of mold, mildew and other microorganisms
by emptying the water tank immediately after each use. If water is left
in the tank for longer than 8 hours, thoroughly clean and disinfect the
unit as described in the section of this Owner’s Guide referenced as
CLEANING.
NOTE: This equipment has been tested and complies with the CFR 47
Part 18 FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This product generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this product does cause harmful interference
to radio or television reception, which can be determined by turning
the product off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that