Clock User Manual

Clock Radio Time & Weather Butler Features:
• Indoor&OutdoorTemperatureDisplay
• Malevoiceannouncestimereportingandalarmmode
• Easy-to-readdisplaywithilluminatedLCD/3-levelwhitebacklight(HI/MED/LO)
• AM/FMDigitalRadiotuningwith8presetmemory
• DualAlarmClock–3WakeModes:Radio,BeepToneorMalevoice(report
looping)
• ConvenientSnooze/Napfunction
• DigitalVolume:1-8level
• Speaker:3”diameter
• Operationtemperature:+32°Fto+122°F(0°Cto+50°C)
• Indoortemperaturerange:+32°Fto+122°F(0°Cto+50°C)
• Operatingfrequency:434MHz
• MaximumTransmissiondistance:100feet(30meters)
• Poweradaptor:120Vacinput6Vdc300mAoutput
• Back-upbattery:CR2032(included)
5
4
Fig. 1
EC-B130_Clock Radio Weather ButlPage 1 7/6/09 4:50:10 PM
Outdoor Temperature Remote Sensor Specifications:
• Outdoortemperaturerange:-4°Fto+140°F(-20°Cto+60°C)
• Operatingfrequency:434MHz
• MaximumTransmissiondistance:100feet(30meters)
• Batterypower:2xAAA(notincluded))
Initial Setup
Alarm Clock Battery Installation:
1. Remove battery compartment cover on the bottom of the unit. Insert one
included CR2032 battery into the unit according to the polarity direction
indicated. Replace cover and snap into place.
2. Attach the DC end of the adaptor into the DC jack on the base of the unit and
insert the AC plug into a 120 VAC outlet.
NOTE: In the event of a power outage the battery is designed to provide memory
back-up for the clock radio settings and alarm settings. The time will not be
illuminated on the clock display when there is no AC power available. As soon as
the power supply returns, the display will indicate the correct time.
NOTE: To hold the time, radio settings and alarm time the back-up battery must
be installed.
Outdoor Remote Sensor Battery Installation:
1.Loosenthe4screwssecuringthebatterycoverwithasmallscrewdriver
(included)andremove.
2. Insert 2xAAA alkaline batteries according to the polarity direction indicated.
3.Placethehomereceiver(ClockRadioTime&WeatherButler)ascloseas
possible to the remote sensor. This will help with synchronization between the
two units.
4.Theremotesensorispresetto°F.Pressthe˚C/˚Fbuttoninsidetheremote
sensortochangebetween°Cand°F.
5.PresstheTXbuttoninsideoftheremotesensortoverifythereception.
6.Replacethecoverandtightenthe4screws.
NOTE: It is recommended to first test the units next to each other to ensure that
both the remote sensor and home receiver are properly synchronized.