Operating Instructions
If the car does not drive straight, use the Wheel
Alignment dial
MONSTER ROCKSLIDE MEGA WHEEL
OPERATING INSTRUCTIONS
The truck requires six AA 1.5V batteries (not included). The controller requires
one 9V battery (not included). When changing batteries, adult supervision is
required. Use alkaline batteries for the best performance.
Locate the battery compartment on the bottom of the truck and the side of the
remote controller and remove the battery cover doors.
Insert AA 1.5V batteries in truck, and 9V batteries into controller and replace
the battery compartment doors and screws.
ii iiii
Turn on the Car and Remote Controller, they will pair
automatically. When operating more than 1 vehicle at
a time, turn on each vehicle and remote pair
separately to allow remotes to pair with the correct
vehicle. Switch both the vehicle and controller power
switches to the “ON” position.
iiiiii
Carefully remove items from package.
Reverse
Forward
Left Turn
Right Turn
Wheel
Alignment
6+
Battery
Cover
On/O
Switch
SAFETY PRECAUTIONS
1-800-374-2744
FOR TECHNICAL SUPPORT,
PLEASE CALL
The artwork and design of this manual are protected by US copyright law and
may not be reproduced, distributed, displaced, published or used for any
purpose without prior written permission. Altering, removing or reproducing
any of the trademark or copyright notices on this package is not permitted.
© 2021 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
Distributed by MerchSource, LLC, Irvine, CA 92618.
• Do not operate during thunderstorms or rain.
• Avoid water, sand and snow when operating car.
• Do not submerge car or controller in water.
• Never operate your car on the street or highway.
• Never operate your car in a confined or crowded area, and do
not use people or animals as obstacles.
• Do not run your car into furniture, objects or hard surface, as
this will cause damage to both the objects and your car.
• Keep fingers, hair and loose clothing away from the tires. gears
and motor while the car is switched to “ON”.
• Do not leave car or transmitter near source of heat or under
direct sunlight for long periods of time.
• Do not leave car or transmitter outside overnight. Dampness is
harmful to interior components.
• Remove all batteries when not in use to avoid accidental
operation.
• Adult supervision is recommended when operating this car.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the pictures on this manual may
dier slightly from the actual product.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
• Insert batteries using the correct polarity.
Do not short-circuit the supply terminal.
• Remove batteries when not in use. Recycle or dispose of
exhausted batteries according to federal, state, and local
laws. Do not dispose of batteries in a fire - they may leak
or explode.
• Only use manufacture specified battery(ies), charger(s)
and/or adapter, if applicable, specified by the manufacturer.
• Always use, replace, and recharge (if applicable) batteries
under adult supervision.
• Keep these instructions for future reference.
Printed in China
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to
• Chich the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
WARNING: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Battery
Cover
Power
Switch
Status
Light
Forward/
Reverse
Left/
Right