Battle Beasts Dueling Robotic Animals SC050 Instructions For ages 8 and older. Read and save these instructions.
Table of Contents Warnings ...................................................................................5 Introduction...............................................................................6 Battery Requirements ................................................................6 Installing Batteries ......................................................................7 Remote Control .........................................................................9 Macro Mode...........................
Head Warnings H1 or H2 • Do not mix old and new batteries. • Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel-Cadmium). • Only use batteries of the same or equivalent type as recommended. • Nonrechargeable batteries should not be recharged. • Rechargeable batteries should be removed from the toy before recharging them. • Rechargeable batteries are only to be recharged under adult supervision. • The supply terminals are not to be short-circuited.
Introduction Each of the Battle Beasts has a sophisticated remote that features dual command buttons and an eight-movement direction pad. The blue Beast is designed in the image of a triceratops. The red Beast evokes the brutish image of a fighting wooly mammoth. Fire infrared laser weapons for long-distance combat, then engage the horn to intimidate your opponent. One on-target blast of the cannon disables your opponent for a full two seconds. LEDs indicate each creature’s battle strength.
Installing Batteries Beast 1. There are two battery compartments located under each Battle Beast. Remove the screw and the battery compartment door from the large battery compartment, using a screwdriver (not included). 2. The large battery compartment will hold 3 AA batteries (purchase separately). Insert the batteries, observing proper +/- polarities. 3. Replace the battery compartment door and the screw. 4.
Installing Batteries Remote Control 1. The battery compartment is located in the stand. Look for the silver screw. Rifle Cannon Stand b 2. Remove the screw and the battery compartment door, using m 1 m2 a screwdriver (not included). 3. Insert 3 AAA batteries (purchase separately), observing proper +/- polarities. 4. Replace the battery compartment door and the screw.
Remote Control Buttons Horn b 8 Directions m 1 m2 Macro 1 Macro 2 HORN: To start combat, slide one Battle Beast’s channel switch to “A” and the other Battle Beast’s channel switch to “B.” To enter Combat mode, press the HORN button. M1 and M2: To restart a new combat session, press both the M1 and M2 buttons for 5 seconds.
Remote Control Auto Off: If a button is not pressed on the remote control within 3 minutes, the remote turns off automatically. If the Battle Beast does not receive a command/signal within 3 minutes, it also turns off automatically. Regardless of whether the Battle Beast is in Combat mode or not, a roaring sound is heard before it turns off. Note: When the RIFLE and CANNON buttons are pressed at the same time, the Beast will fire the Cannon first. If the Cannon is reloading, then the Beast will fire the Rifle.
Macro Mode Press M2 and the desired direction button for more than 5 seconds. The Beast finishes the corresponding attack route. Because the Beast’s motor will be influenced by ground surface, electric current and voltage, etc., there may be a slight inaccuracy in the routes. Macro mode 1 and Macro mode 2 cannot respond at the same time. If they are pressed simultaneously, the Beast responds only to the first button pressed.
Macro Mode Left direction button + M1: Go to the rear of the opponent from the left and fire CANNON. Right direction button + M1: Go the rear of the opponent from the right and fire CANNON.
Macro Mode Up Direction button + M1: Go the side of the opponent from the left and attack. Down button + M1: Go the side of the opponent from the right and attack.
Macro Mode Left button + M2: Go to the back of the opponent from the left and fire CANNON. Right button + M2: Go to the back of the opponent from the right and fire CANNON.
Macro Mode Up button + M2: Go the side of the opponent from the left and attack. Down button + M2: Go to the side of the opponent from the right and attack.
Game Rules Game Rules Table Life Energy Directions Cannon Cannon Rifle Shots Reload Reload Time Time Shield Time Immobile Time Disarm Time 10 8 40 4 sec. 2 sec. 5 sec. 4 sec. 3 sec. Description of Weapon Features Directions: There are a total of 8 directions: Forward; Back; Left; Right; Forward and Left; Forward and Right; Back and Left; and Back and Right. Reload Time: There is approximately a 4-second reloading time between each Cannon shot; 3 seconds for a Rifle shot.
Game Rules Immobile Time: When the Beast is shot by Cannon or Rifle, it cannot move for 2 seconds. However, the Rifle is still active. Disarm Time: When confronted with a body attack, the Beast cannot use the Rifle for 5 seconds. However, the Beast can still move. Rules for Victory or Defeat If your opponent’s “Life Energy” points decrease to zero, you and your Beast win the game. Each successful attack by Cannon, Rifle or Body Attack decreases one “Life Energy” point.
Status Indicators Dance Indicators Power On Dance: After powering on your Beast, it plays a dance as detailed below: Forward ➞ left 45° ➞ right 90° ➞ left 45° ➞ horn for one second ➞ roar. If the Beast has finished dancing, it plays the Power On sound and enters into a prewar status. When the Beast is performing the dance, the user can press HORN to interrupt the dance. The Beast makes a revved-up-ready-for-battle sound, indicating it is ready to enter Combat status.
Status Indicators Left Eye LED Cannon In Combat status, ON means reloaded; OFF means reloading or cannon shots depleted. Cannon Firing Indication When firing cannon, it blinks once every 0.2 seconds. Channel Indication After the Power On Dance, a blinking LED means channel A is selected before entering Combat status. Right Eye LED Rifle In Combat status, ON means reloaded; OFF means reloading. Rifle Firing Indication When firing rifle, it blinks once every 0.2 seconds.
Status Indicators Top LED Precombat Status Indication Between power on and combat status, green LED blinks 3 times, then the orange LED blinks 3 times. Life Energy Indication in Combat Status The color of LED indicated the life energy of the Beast as detailed below: Life Energy 6-10: Green Life Energy 2-5: Orange Life Energy 1: Red Attacked by Cannon In combat status, when attacked by cannon, red LED flashes once, then it’ll be on for 0.8 seconds. It returns to Life Energy Indication status.
Status Indicators Attacked by Opponent Body When attacked by opponent body, red LED flashes 3 times, then it’ll be on for 0.6 seconds. It’ll return to Life Energy Indication status. Sound Indicators On: Power on as well as entering Sleep mode. Battle: Entering combat status. Rifle: A firing rifle. Cannon: A firing cannon. Attacked: A Beast is being attacked. The attack includes rifle, cannon and body attack. Lose: A Beast has lost a battle. The sound lasts approximately 15 seconds.
Statement of FCC Compliance WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Statement of FCC Compliance • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for assistance. FCC Label Compliance Statement This device complies with Part 15 of the FCC Rules.
Warranty What Is Covered This warranty covers any defects in materials or workmanship, with the exceptions stated below. How Long Coverage Lasts This warranty runs for 90 days from the date of original purchase. What Is Not Covered This warranty does not cover damage caused by misuse or use other than as intended and described in the product instruction manual, or loss or damage to batteries or removable parts.
