Operating Instructions
FLIP STUNT RALLY
OPERATING INSTRUCTIONS
Vehicle requires four“AAA” 1.5V batteries (not included). Remote control
requires one 9V battery (not included). When changing batteries, adult
supervision is required. Use alkaline batteries for best performance.
The screw to the battery compartment is located under the white side of the
vehicle. Unscrew the white side of the car using a standard screwdriver. Insert
“AAA” batteries while observing the correct polarity. Replace the white side of
the vehicle. Replace screws.
Slide of battery cover on back of transmitter. Insert one 9V battery according to
the polarity diagram on the battery tray. Replace battery compartment and
battery cover.
ii iiii
Switch both car and remote buttons to “ON” position.
For best result use the car on hard surfaces such as
wood or tile. For best flipping performance, use on
asphalt or carpeted surfaces.
iiiiii
Carefully remove items from package.
Reverse
Forward
Spinning Action
Flipping Action
6+
Battery
Cover
Screw
SAFETY PRECAUTIONS
1-800-374-2744
FOR TECHNICAL SUPPORT,
PLEASE CALL
Led Power
Indicator
On/O
Switch
On/O
Switch
NOTE: YOUR STUNT VEHICLE WORKS BEST IN LARGE, OPEN AREAS.
- AAA 1.5V + - AAA 1.5V +
- AAA 1.5V + - AAA 1.5V +
(SHOWN WHITE SHELL UP)
The artwork and design of this manual are protected by US copyright law and
may not be reproduced, distributed, displaced, published or used for any
purpose without prior written permission. Altering, removing or reproducing
any of the trademark or copyright notices on this package is not permitted.
© 2020 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
Distributed by MerchSource, LLC, Irvine, CA 92618.
Model NO.: 1009537
• Do not operate during thunderstorms or rain.
• Avoid water, sand and snow when operating car.
• Do not submerge car or controller in water.
• Never operate your car on the street or highway.
• Never operate your car in a confined or crowded area, and do
not use people or animals as obstacles.
• Do not run your car into furniture, objects or hard surface, as
this will cause damage to both the objects and your car.
• Keep fingers, hair and loose clothing away from the tires. gears
and motor while the car is switched to “ON”.
• Do not leave car or transmitter near source of heat or under
direct sunlight for long periods of time.
• Do not leave car or transmitter outside overnight. Dampness is
harmful to interior components
• Remove all batteries when not in use to avoid accidental
operation
• Adult supervision is recommended when operating this car.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the pictures on this manual may
dier slightly from the actual product.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
• Insert batteries using the correct polarity.
Do not short-circuit the supply terminal.
• Remove batteries when not in use. Recycle or dispose of
exhausted batteries according to federal, state, and local
laws. Do not dispose of batteries in a fire - they may leak
or explode.
• Only use manufacture specified battery(ies), charger(s)
and/or adapter, if applicable, specified by the manufacturer.
• Always use, replace, and recharge (if applicable) batteries
under adult supervision.
• Keep these instructions for future reference.
Printed in China