Operating Instructions

If the car does not drive straight, use the Wheel
Alignment dial
PHANTOM DESTROYER
OPERATING INSTRUCTIONS
ii iiii
Switch both car and remote buttons to “ON” position.
For best result use the car on hard surfaces such as
wood or tile.
iiiiii
Carefully remove items from package.
Left Turn
Right Turn
Wheel
Alignment
6+
On/O
Switch
On/O
Switch
Led Power
Indicator
The artwork and design of this manual are protected by US copyright law and
may not be reproduced, distributed, displaced, published or used for any
purpose without prior written permission. Altering, removing or reproducing
any of the trademark or copyright notices on this package is not permitted.
© 2018 Sharper Image. Sharper Image® name and logo are registered
trademarks. All rights reserved.
© 2018 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
Distributed by MerchSource, LLC, Irvine, CA 92618.
• Do not operate during thunderstorms or rain.
• Avoid water, sand and snow when operating car.
• Do not submerge truck or controller in water.
• Never operate your truck on the street or highway.
• Never operate your truck in a confined or crowded area, and do not
use people or animals as obstacles.
• Do not run your truck into furniture, objects or hard surface, as this
will cause damage to both the objects and your car.
• Keep fingers, hair and loose clothing away from the tires. gears and
motor while the car is switched to “ON”.
• Do not leave truck or remote control near source of heat or under
direct sunlight for long periods of time.
• Do not leave truck or remote control outside overnight. Dampness is
harmful to interior components.
• Remove all batteries when not in use to avoid accidental operation.
• Adult supervision is recommended when operating this car.
Due to continuous product improvements, the pictures on this manual may
dier slightly from the actual product.
SAFETY PRECAUTIONS
1-800-374-2744
FOR TECHNICAL SUPPORT,
PLEASE CALL
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT
INFORMATION FOR FUTURE REFERENCE.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable batteries.
• Insert batteries using the correct polarity.
Do not short-circuit the supply terminal.
• Remove batteries when not in use. Recycle or dispose of
exhausted batteries according to federal, state, and local
laws. Do not dispose of batteries in a fire - they may leak
or explode.
• Only use manufacture specified battery(ies), charger(s)
and/or adapter, if applicable, specified by the manufacturer.
• Always use, replace, and recharge (if applicable) batteries
under adult supervision.
• Keep these instructions for future reference.
Forward
Reverse
The truck requires 4 AA 1.5V batteries (not included). The controller
requires one 9V battery (not included). When changing batteries,
adult supervision is required. Use alkaline batteries for the best
performance. Locate the battery door on the bottom of the truck.
Using Phillips screwdriver to loosen the screw, pull the latch on the
door and lift up to access the battery compartment. Insert 4 AA
batteries while observing the correct polarity. Replace the battery
compartment door and tighten the screw.
Using Phillips screwdriver to loosen the screw and remove the
battery compartment door. Insert one 9V battery while observing
the correct polarity. Replace the battery compartment door and
tighten the screw.
Battery
Cover