User's Manual

45602 Instructions, Revision a.5 4/4/2007 6:26:10 PM
Page 4 of 4
limitations may not apply to you. This warranty gives you specific rights, and you may also have other rights which
vary from state to state. If the unit should prove defective within the warranty period, return prepaid with dated proof
of purchase to:
JASCO Products Company
10 E Memorial Rd.
Oklahoma City, OK 73114
CERTIFICATIONS
UL Listed – Add Details
FCC Information
The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:
The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment uses, generates and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communication. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Operation is subject to the following two conditions:
• This device may not cause interference and
• This device must accept any interference, including interference that may cause undesired operation of the
device.
Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the
device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure
requirements and void user’s authority to operate the device.
SPECIFICATIONS
Power 120VAC, 60Hz
Signal (Frequency) 908.42 MHz
Maximum Load for the Z-Wave controlled outlet; 300 W Incandescent
Maximum load for both outlets 15 Amps, 1800W Resistive
Range: Up to 100 feet line of sight between the Wireless Controller and the closest Z-Wave receiver module.
Operating Temperature Range: 32-104° F (0-40° C)
For indoor use only.
Z-Wave is a registered US trademark of Zensys A/S
SmartHome is a trademark of JASCO Products