User's Manual

45603 Instructions, Revision a.4 4/4/2007 6:28:29 PM
Page 1 of 3
45603
Z-Wave, RF Controlled, 600W, 120 VAC, Plug-In Fluorescent Light & Appliance Module
R
Add callouts for Z-Wave
and Pass Through outlets
Thank you for your purchase of a GE SmartHome™ Z-Wave
®
control device. Z-Wave technology is designed to
automate lighting/home control and provide easy remote operation of all your Z-wave enabled devices. The GE Z-
Wave product family includes a variety of devices to enable and control lighting in your home. It is up to you whether
you want to control one room or your entire house and whether you want to do it all now or start with one room and
add more over time.
This module is one component of a Z-Wave
®
control system and is designed to work with all other Z-Wave enabled
devices in a home control network. It will also act as a wireless repeater to insure that commands intended for
another device in the network are received, thereby extending the range of the wireless controller. Z-Wave devices
of other types and brands can be added to the system and will also act as range extenders if they support this
function of repeating the signal received to other nodes in the system.
The device plugged into the Z-Wave controlled outlet on this module must not 600 watts (Incandescent); 1800W
(15A) Resistive or ½ HP Motor. Total load capacity for both outlets is 1800W(15A) Resistive.
There are no user serviceable parts in this unit.
Key Features
• One Z-wave controlled AC outlet
o Remote ON/OFF control via the Z-Wave controller
o Manual ON/OFF control with the front panel pushbutton
• One Always-ON pass-through AC outlet
• Space efficient design
o Does not block the 2
nd
outlet in a duplex wall receptacle
o Plugs and cords for connected devices route to the side allowing close placement of furniture
Basic Operation
Manual Control
The Front Panel Pushbutton on the 45603 Appliance Module allows the user to:
1. Manually turn the connected equipment ON or OFF by pressing the button.
• This is a toggle switch; if the device is OFF, pressing the button turns the device ON and vice versa.