User's Manual

45605 Instructions, Revision a.5 4/4/2007 6:58:13 PM
Page 3 of 4
Configuration
Please note: Not all controllers are capable of this; your controller must be designed to perform this function.
The GE model #45601 is designed to do this. Use its “Setup Menu”, “Config Unit” to change the configuration
of devices.
LED Light
When shipped from the factory, the LED on the 45605 is set to turn ON when the connected outlet is turned OFF. To
make the LED turn ON when the light is turned ON, change parameter 3’s value to “0”.
• Parameter No: 3
• Length: 1 Byte
• Valid Values = 0 or 1 (default 1)
Restoring Factory Defaults
All network settings and configuration parameters can all be restored to their factory default settings by using your
master controller to reset the device. Please note: The GE model #45601 controller is designed to do this. Use
the controller’s “Setup / Reset Unit” menu to restore defaults. Not all controllers are capable of this; your
controller must be designed to perform this function.
Over-Current Protection
Additional over-current protection is provided by an internal fuse which is not user serviceable. Check your home’s
circuit breakers before concluding that the product must be replaced.
Interoperability with Z-Wave™ Devices
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. Although every Z-Wave certified product is designed to work with all other Z-Wave certified products,
your controller must include the appropriate device classifications in order to control non-lighting Z-wave devices. As
an example, the GE 45600 basic remote is designed only for controlling Z-Wave devices using the lighting control
classification. The GE 45601 deluxe remote with LCD readout can control other Z-Wave certified devices like
thermostats as well as lighting.
WARRANTY
JASCO Products warrants this product to be free from manufacturing defects for a period of two years from the original
date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not
extend to consequential or incidental damage to other products that may be used with this product. This warranty is in
lieu of all other warranties, expressed or implied. Some states do not allow limitations on how long an implied warranty
lasts or permit the exclusion or limitation of incidental or consequential damage, so the above limitations may not apply
to you. This warranty gives you specific rights, and you may also have other rights which vary from state to state. If
the unit should prove defective within the warranty period, return prepaid with dated proof of purchase to:
JASCO Products Company
10 E. Memorial Rd.
Oklahoma City, OK 73114
CERTIFICATIONS
UL Listed – Add Details
FCC Information
The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:
The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment uses, generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference