User's Manual

45652 Instructions 8/25/2010 10:11:20 AM
Page 4 of 7
Basic Operation
The connected light can be turned ON in three ways:
1. With a remote
2. Manually with the pushbutton on the Z-Wave module
3. By the Load-Sensing feature. Normally, the Z-Wave module controls the ON/Off state of the connected light
and power is either turned On or Off at the module (either manually or by the remote). If the switch on the
connected light is used, the Z-Wave control circuitry automatically senses that the light is being turned On
and activates the Z-wave controlled outlet, providing power to the connected device. This feature is disabled
by default; see the section on advanced operation for instructions on how to enable it.
Remote Control
GE Z-Wave remotes provide control of an Individual device, Groups of devices and Scenes. Other brands of Z-
Wave Certified remotes may not offer as much flexibility in how you can set up your lighting control network. Please
refer to your remote control’s instructions for details on its capabilities and instructions for adding and controlling
devices.
Manual Control
The Front Panel Pushbutton on the 45652 Lamp Module allows the user to:
1. Manually turn the connected lighting ON/OFF by pressing the button.
• This is a toggle switch; if the light is OFF, pressing the button turns the light ON and vice versa.
2. Adjust the brightness level of the connected lighting by pressing and holding the button. Release the button
when the desired level is attained.
• This is also a toggle function. The lighting will dim until the minimum level is attained or the button is
released. The next time the button is pressed and held, the level will increase until the maximum level is
attained or the button is released.
3. Include or exclude the module from the Z-Wave home control network with your primary controller.
• Refer to the instructions for your primary controller to access the setup function and include or exclude
devices.
• When prompted by your primary controller, tap the button (press and release).
• The primary controller should indicate that the action was successful. If the controller indicates the
action was unsuccessful, please repeat the procedure.
• Once the module is part of the network, the same basic procedure is used to add the module to groups
or scenes. Refer to the primary controller’s instructions for details.
Please Note: After a power failure, the 45652 module returns to its last used ON/OFF/DIM state.
ADVANCED OPERATION
The following Advanced Operation parameters require that you have an advanced controller like the GE model
45601 LCD remote. Advanced remotes from other manufacturers may also be able to change these settings;
however, basic remotes do not have this capability.
All On/All Off
Depending upon your primary controller, the 45652 lamp module can be set to respond to ALL ON and ALL OFF
commands in up to four different ways. Some controllers may not be able to change the response from its default
setting. Please refer to your controller’s instructions for information on whether or not it supports the configuration
function and if so, how to change this setting.
The four possible responses are:
• It will respond to ALL ON and the ALL OFF commands (default).
• It will not respond to ALL ON or ALL OFF commands.
• It will respond to the ALL OFF command but will not respond to the ALL ON command.