User Guide

USER AND SAFETY GUIDE

Shelly Wall Switch

This document contains important technical and safety information about the device and its safety

use and installation.

⚠CAUTION! Before beginning the installation, please read this guide and any other documents

accompanying the device carefully and completely. Failure to follow the installation procedures

could lead to malfunction, danger to your health and life, violation of the law or refusal of legal

and/or commercial guarantee (if any). Allterco Robotics is not responsible for any loss or damage

in case of incorrect installation or improper operation of this device due to failure of following the

user and safety instructions in this guide.

Shelly Wall Switches should be used in combination with Shelly devices or other smart de-

vices designed to work with similar switches. (The potential between Power and Switch

input of the controlled devices should not exceed 12V (it’s 3.3V for Shelly devices). Shelly

Wall switch cannot be used to switch the main power through any kind of load.

⚠CAUTION! Danger of electrocution. The mounting/installation of the Device should be done by

a qualied person (electrician).

⚠CAUTION! Do not connect the Device to appliances exceeding the given max load!

⚠CAUTION! Use the Device only with a power grid and appliances which comply with all appli-

cable regulations. short circuit in the power grid or any appliance connected to the Device may

damage the Device.

⚠CAUTION! Before starting, wire check that the breakers are turned off and there is no voltage

on their terminals. This can be done with a phase meter or multimeter. When you are sure that

there is no voltage, you can start wiring the cables.

Example:

Connecting several switches to one device:

You can connect an innite number of switches to control the same device, for this purpose,

they must be connected in parallel.

Example:

L O1

For more wiring diagrams please visit:

https://shelly.cloud/knowledge-base/devices/shelly-wall-switch/

DECLARATION OF CONFORMITY

Hereby, Allterco Robotics EOOD declares that the radio equipment type Shelly Wall Switch is

in compliance with Directive 2014/35/EU, 2011/65/EU. The full text of the EU declaration of

conformity is available at the following internet address:

https://shelly.cloud/knowledge-base/

devices/shelly-wall-switch/

Manufacturer: Allterco Robotics EOOD

Address: Bulgaria, Soa, 1407, 103 Cherni vrah Blvd.

Tel.: +359 2 988 7435

E-mail: support@shelly.cloud

Web: http://www.shelly.cloud

L O1

L O2O1

PAGE 1
Connecting several switches to one device: You can connect an infinite number of switches to control the same device, for this purpose, they must be connected in parallel. Example: L L O1 N L O1 For more wiring diagrams please visit: https://shelly.cloud/knowledge-base/devices/shelly-wall-switch/ DECLARATION OF CONFORMITY Hereby, Allterco Robotics EOOD declares that the radio equipment type Shelly Wall Switch is in compliance with Directive 2014/35/EU, 2011/65/EU.
PAGE 2
Specification Maximum switching potential: 12V DC / 18V AC Maximum switching current: 50mA Maximum power supply: 230V Operating temperature: -20°C to 70°C Operating humidity: up to 85% N N L L N L L Wiring: O1 L O2 O1 Еach cable has a color code: Red - Power supply; Black - Switch 1; Blue - Switch 2; Green - Switch 3; White - Switch 4 Assembling: 1. Connect the Red cable with the L of the switch to the same supply voltage/phase as for the Shelly device or Sx output. 2.