Instructions / Assembly

Location and Installation

NOTE: Before beginning installation, consult proper local authorities regarding local codes governing all such applications and

installations.

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. Your furnace must be placed on a non-

combustible oor. Position the furnace as close to the chimney as possible. Air for combustion must be provided into the room where the

furnace is located. Allow air free access to the furnace for combustion and ventilation.

Garage installs are not recommended due to National re codes. Consult with your local code and insurance company.

When installing an indoor furnace, the heat plenum coming off the top of the appliance can only go up or horizontal to connect into the

main supply duct. Never run the plenum down as this will create a heat buildup in the furnace causing the blower to short cycle and

damage the blower motor and will not be covered under warranty. This is not a down draft furance and not to be installed as one. If you

do not have a basement and the plenum cannot be put in the ceiling, then we recommend our outdoor Shelter Furnace.

RECOMMENDATION: Purchase Chimfex™ Dry Chemical Chimney Fire Extinguisher. These are readily available at most stove shops

and hardware stores. Smoke detectors and carbon monoxide monitors should be installed on all levels of your home. Having a re

extinguisher in the furnace room or area is strongly recommended.

Assembly of Unit

Please review the parts list and diagrams contained on pages 15 - 17 of this manual.

DOUBLE CHECK TO MAKE SURE YOU HAVE RECEIVED ALL THE REQUIRED

COMPONENTS. IF YOU FIND THAT THERE IS A PART MISSING, CALL

1-800-875-4788 FOR FASTEST SERVICE, PLEASE DO NOT GO BACK TO THE

STORE. STORE DOES NOT CARRY REPLACEMENT PARTS.

RETURN AIR

DUCT

SUPPLY

DUCT

BACK DRAFT

DAMPERS

OPEN/CLOSE RETURN

DAMPERS - 3 PLACES