Use and Care Manual

21
Problem: Draft blower runs constantly.
• Defective wall thermostat.
• This can be checked by turning the thermostat to a lower setting
than the temperature in your home. If the draft blower continues to
run, the thermostat may be defective. Replace if necessary.
Possible Causes:
Remedies:
• Defective relay in transformer. • Replace transformer and relay.
• Have a professional determine the proper size furnace and
insulation factor of your home.
• Home is not being supplied with
a sufcient amount of heat to
satisfy the wall thermostat.
7.
Problem: Rapid accumulation of creosote in furnace and ue.
• Use of high resin wood, such
as pine.
• Completely avoid using if at all possible. If hardwoods are not
available, fuel the furnace with smaller loads. This will cause
the thermostat to call for more heat more often, which will
initiate the running of the draft blower. Consequently, the res
will be hotter, thereby reducing the accumulation of creosote.
Possible Causes:
Remedies:
• Under-ring the furnace has
caused low ue gas temperature.
• Install ue gas thermometer and maintain stack temperatures
between 300° and 400° F.
• See #9.
• Insufcient chimney draft.
8.
• Improper connection in stove
pipe causing air leakage or a
structural defect in the chimney
itself.
• Inspect entire ue run, from the exhaust stack of the furnace to the
termination cap. Repair as necessary.
• Fire box not receiving adequate
amount of oxygen.
• Furnace room may be too airtight to supply sufcient amount of
oxygen for combustion. Install an aperture to the outside consisting
of a minimum of 12 square inches or 4 inches round.
• Install stainless steel liner in masonry chimney to reduce creosote
formation and improve draw. Use appropriate size stainless liner for
the furnace.
• DANGER: Never use uninsulated stove pipe as chimney. It must not
be used on the inside of your home due to high stack temperatures,
which create an extreme re hazard. Uninsulated pipe cannot be
used as an outside ue because it causes rapid cooling of the stack
gases, which causes them to condense as creosote on the inside of
the ue.
• Use of an unlined masonry
chimney with a large clay tile
opening.
• Using uninsulated stove pipe
for the chimney, especially if the
construction is on the exterior of
the home.