20' x 20' Celebration Canopy Assembly Instructions Before you start: 2+ individuals recommended for assembly, approximate time 2 hours. Recommended tools: Step Ladder ShelterLogic, LLC 150 Callender Road Watertown, CT 06795 www.shelterlogic.
ATTENTION: This Shade/Canopy product is made with the highest quality material available and is designed to fit the ShelterLogicâ„¢ custom fabric cover included. ShelterLogicâ„¢ Canopies offer protection from sun, light rain, tree sap, animal - bird excrement and light snow. Please anchor this shelter properly. See manual for more anchoring details. Proper anchoring, keeping cover tight and free of snow, pooling water and debris is the responsibility of the consumer.
20' x 20' Celebration Canopy Assembly Instructions Model #25797 Quantity Part # 28.8" Rafter Tubes 4 14007 56" Rafter Tubes 12 14008 56" Rafter Tubes 4 14009 36.6" Top Cross Rails 8 14010 59.4" Cross Rails 16 14011 59.4" Cross Rails 16 14004 42.4" Upright Tubes 8 14012 42.
ASSEMBLY OF CANOPY 1. LAYOUT ROOF FRAME: Assembly is easiest if you layout all frame parts as shown. Assemble center peak roof, then assemble each side. NOTE: Use Rubber Hammer to insert last corner of top roof frame assembly. Quantity of Parts Mfg.
2. ATTACH LEGS TO FRAME: A. Install the upper leg tubes (14012). Put all 3 tubes in one side then assemble other side. Finally insert 2 center tubes. B. Ensure all round pins are popped out. See Figure 1. 14012 3. SECURE THE COVER: A. Drape cover over frame. See Figure 2. B. Insert clips into holes in poles at 4 corners shown in photo. See Figure 3. C. Attach hook and eye closures at each rafter rib. See Figure 4. D. At center of each side, insert webbing into clip and tighten. See Figure 5.
4. INSTALL LEGS: A. Install Lower leg tubes (10392) into each leg. B. Ensure all round pins are popped out. See Figure 1. 10392 10392 10392 5. ATTACH AND SECURE FEET: A. Insert the foot plates onto the bottom of the legs by lifting each leg and slide the foot onto the pole leg. Rotate the foot until the hole aligns with the hole in the pole leg. Insert 1 pin (10052) into each hole to secure each foot. Repeat for each leg. B. Insert two anchors into each of the foot plates.
NOTES: Page 7 05-25797-0C
ShelterLogic, LLC 150 Callender Road Watertown, CT 06795 www.shelterlogic.