Instructions / Assembly

05_10B163_0EPage 10
8. INSTALLING THE COVER ON THE FRAME:
A. Lay the cover on the ground next to the
frame with the inside of the cover (the side
with the pipe pockets) facing down and the
webbing on the front and rear of the corner
of the building. Position the cover so that it
is centered on the frame, front to back. See
Detail J.
B. Fold over the side so the pipe pocket is
now accessible. Insert a cover pipe into the
pipe pocket slot, at the rst middle rib from
the front and the rst middle rib from the
rear. Some of the pipe will be exposed. For
long buildings it may be necessary to use
additional pipes in the middle. See Detail K.
Remove pocket pipe to install later.
C. Tie the rope on each of the exposed
pipes and throw the other end of the rope
over the frame. See Detail L.
D. Move to the other side of the frame and
pull the cover over the frame with the rope.
This may require two or more people. See
Detail M. Check that the Logo reads upright
as shown.
DETAIL J
DETAIL K
DETAIL L
DETAIL M
END PANELS
AND WIND
BRACES NOT
SHOWN FOR
CLARITY.
NOTE: CHECK THAT YOUR COVER IS
CORRECTLY PLACED ON THE FRAME.
The ShelterLogic
®
logo should line up on the left front and
right rear corners near the top rail. If the logo is not legible,
the cover has not been put on the frame correctly.
COVER RAIL SHOWN
ASSEMBLED.