Instructions / Assembly

05_10B163_0EPage 8
A. The anchors should be positioned at the four corners and the remaining should be spaced evenly
on both sides of the shelter.
B. Using the provided steel driving rod and a sledge hammer, drive each anchor into the ground leav-
ing approximately 8 inches of cable exposed above the surface.
C. Remove the driving rod, insert it through the loop of the cable and pull up on the cable to set the
anchor.
D. After the anchors are rmly set, wrap the cable around the base rail and clamp (10016). Be sure to
remove all slack from cable. See Detail G.
6. INSTALL EASY-HOOK EARTH ANCHORS:
Base
Rail
DETAIL G
11133
5. INSTALL TOP RAIL:
Place the rst top rail under each end rib and secure it with a
bolt as shown in Detail F.
The same cross rail should lay on top all of the middle ribs.
Secure the rails to the frame with the hardware indicated in
Detail F.
The top rail attached to the last rib will be installed under the
pipe.
DETAIL F
11134
Install the Top Rail
OVER all Middle Ribs
UNDER First and Last Ribs