User's Manual

8
/
12
other barriers can be used in between to increase isolation.

Fix the donor antenna after selecting the best position, and adjust slightly its height
or angles in order to get the signals with suitable input power l evel and calling
quality.
（2）Installation of Indoor Antenna

Proper antennas shall be selected according to the site conditions and the
requirement.

Omni antenna (Indoor ceiling omni antenna or whip antenna), is suitable to be
installed in the center and radiate all directions.

Indoor antenna must be operated at a fixed location inside a building, it is better to
use a directional panel antenna when the coverage building is long and narrow.
 Connect the indoor antenna to the booster connector marked INDOOR with 20 FEET
3D-FB Coaxial cable with N male connector
Notes：
Booster transmitting in 1710-1755 MHz should be install/operate in one of two ways:
(i) the antenna for the device must be installed to comply with the 10 meter above
ground maximum antenna height limitation OR
(ii) the antenna for the device has a 10 meter above ground maximum antenna height
limitation when the device is used with a handset that covers the 1710-1755 MHz band and
that owners could be subject to potential FCC enforcement action for noncompliance.
（3）Booster Installation

Do not place the equipment in direct sunlight or in an area that has abrupt
temperature and humidity changes .

it is suggested that the booster is i nstalled in a cool，dry and ventilated room without
erosive gas and smoke.

Connect power adaptor to the booster，connect The other end of power adaptor to the
power outlet.
WARNING:
The input voltage for the booster is 5~12V DC. DO NOT use this Booster with a regular
power supply that NOT 5~12V DC . otherwise, it will be damaged and the user may also
be injured.
TROUBLESHOOTING AND SUPPORT