User's Manual

Tips

 Under the Universal Repeater mode, press the RE/RST button on the Wi-Fi Range Extender

upper panel with the up level router’s WPS/QSS button at the same time about 1-3s, the Wi-Fi

Range Extender will automatically connect with the up level router.

 Under the Universal Repeater mode, after connected with up level router, if the up level router

appear offline condition (such the up level router power off or reboot or change the channel

and so on), the Wi-Fi Range Extender will test automatically and reconnect with the up level

router again (If connect failed, please manual change the Wi-Fi Range Extender’s channel

and expended channel same as the up level router).

3.4 Network Settings

Click ―Network Settings‖ enter the Network setup web page，in this page you can set ―LAN

Settings‖, ―DHCP Server‖, ―DHCP List & Binding‖.

3.4.1 LAN Settings

This page is to configure the basic parameters for LAN port. This IP address is to be used to

access the Wi-Fi Range Extender’s settings through a web browser. Be sure to make a note of any

changes you apply to this page.

Set Steps：

① Click “Network Settings”.

② Select “LAN Settings”.

③ Enter IP Address，Subnet Mask.

④ Click “Save” and wait for the device reboot automatically.