User's Manual

a) Make sure that the Ethernet cable (RJ-45) is properly connected to the Device’s Adapter’s

Ethernet port.

b) Make sure that the other end of the Ethernet cable (RJ-45) is properly connected to the

computer LAN card or to you Cable/xDSL Ethernet port.

c) Make sure your computer LAN card is properly installed and configured.

d) Make sure your Cable/xDSL broadband access is working and configured correctly.

e) Contact your local dealer for technical support if the Ethernet LED is still failed to light up

after the above procedures.

3. The Device’s LED does not light up.

Ans. Check the following:

a) Try to plug a second Device Adapter into a nearby power outlet and check whether the

Device LED lights up or not.

b) Contact your local dealer for technical support if the Device LED is still failed to light up

after the above procedures.

3 Factory default settings

The table below lists the factory default settings of your device.

Item

Default settings

192.168.1.1

Domain

mtc.setup.cn/ re300x.setup.cn

admin

LAN Settings

IP Address

192.168.1.1

Subnet Mask

255.255.255.0

DHCP Server

Enabled

IP Pool

192.168.1.100~192.168.1.200

Wireless

Enabled

SSID

RE300x_XXXXXX(where XXXXXX

is the last six characters in the

device's MAC address)