User's Manual

8
OFF
No active connection.
WIFI
Flashing
WiFi Function is On
OFF
WiFi Function is OFF (you can setting the WIFI
function ON/OFF in the BASIC settings)
LAN
On
A device is connected to the ETHERNET port.
OFF
No device is connected to the ETHERNET port.
 RE/RST:
 Under the electricity situation, press and hold the button (about 6 seconds) until all the
LEDs turn on momentarily, then release the button and wait the Wi-Fi Range Extender to
reboot to its factory default setting. You can enter the Wi-Fi Range Extender use the
default password(password: admin).
 Under the Universal Repeater mode, press the RE/RST button on the Wi-Fi Range
Extender upper panel with the up level router’s WPS/QSS button at the same time about
1-3s, the Wi-Fi Range Extender will automatically connect with the up level router.
2.1.2 The product rear panel
Button and Interface description
 LAN Port: LAN jack (RJ45), used to connect LAN in hub, switch or installed network card
computer.