User's Manual

Set reminder types: ring, vibration, ring and vibration, vibrate after ringing, mute

Select ringtone

Select the notification tone

10.7 Action

Incoming call flipping mute: When it is turned on, the watch will be muted when there is an

incoming call flipping

Alarm clock rollover and mute: When it is turned on, the alarm clock is time to rollover the

watch to mute

Gesture wake-up system: when it is turned on, tilt the watch to turn off the screen, lay the

watch flat, and the screen will light up 90 degrees toward you

Shake to answer a call: When it is turned on, the caller interface shakes the watch two or

three times to answer the call

10.8 Restore factory settings

Click on the watch to restore factory settings → After the watch automatically restarts, all data

from the previous operation of the watch will be cleared and it will be restored to the initial state.

10.9 About

Can check the watch Bluetooth name, device address, Bluetooth address, and watch software

version number

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used

in portable exposure condition without restriction.