User's Manual

H- Coding
I Fail safe protection
●Menu display: COD 21 (helicopter mode)
●Function: Coding
●Function description: this transmitter is 2.4G DSSS+hopping system, with high anti-interference
performance. It is assigned with unique Address code, you need to coding with the compatible 2.4G
receivers.
Caution: when
the transmitter in Simulator mode, the screen display OFF, coding function is
disabled.
●Setting method:
1, press Menu to enter COD
2, Press and hold + button to start coding. Coding process need to be completed in short distance. Coding
function is not active when 2.4G module being shut off. Please refer to TRSI training and simulator setting.
The screen will back to stand by mode after coding successfully complete. You can also press and hold
Menu button to exit.
Warning: Do not use the transmitter during coding process.
●Menu display: F'S 22 (helicopter mode)
●Function: Fail safe
●Function description: This function is to protect the servo when the receiver disconnected with the
transmitter, the receiver will hold the servo in
the current position or back to the preset position.
●Setting method:
1,press menu to enter F'S 22 Fail safe. When transmitter setting is TRSI, will display off. And the fail safe
function is shut off.
2, press up/down button to select channel every channel can be set individually. Servo will first
move to
preset position. If the channel setting was in KEEP mode, the server will remain the last active position.
3, for safety consideration, throttle production setting is -150%, the motor will stop running when the
transmitter turns off. When throttle protection set to KEEP mode, please push the throttle stick to the bottom
before shutting off the transmitter. Please refer to the program setting procedure. Press down button to
switch to KEEP or preset mode. Press Menu button to save and exit after complete.
Basic opera tion
Initial setup
Caution
Warning
13