User's Manual

Helicopter
01-REVR
02- EPA
●Function description
Reverse setting function can be used to adjust the action direction of the channel, change the direction from
normal to reverse.
For Helicopters, please set the servo's direction before setting other parameters.
For Airplane and gliders, please set the servo's direction after other parameters being adjusted.
●Setting methods
1,
after power on, press and hold menu to enter setting, displayed REVR01
2, press UP/DOWN button to select the CH you need
3, Press+/- to adjust Nor or REV
4, press and hold Menu to exit or press menu to switch to the next item.
Caution: Change EPA setting will also change de D/R Value. User need to set the EPA
before D/R value. The preset D/R value will be changed during EPA setting.
●Function description
Using this function to set the individual servo's travel on a specific direction without affecting the other. The
value can be adjusted in between 0% to 150%. The smaller the value is, the shorter the travel distance, and
vice versa. When the servo's setting on
a specific direction is 0%, the servo will not move on that direction.
e.g. set the highest value of the throttle to avoid Carburetor overrun. Set the lowest value to choose the
proper Carburetor closing point.
●Setting method:
↓means the EPA negative ↑means the EPA positive
1, press and hold Menu button to enter setting mode after power on, shows EPA 02
2, press UP/Down to select the channel need to be adjusted
3, press +/- to change the value
4, press and hold menu button to exit setting or press menu button switch to next setting.
channel, use UP/DOWN
button to change
NOR/REVR, use +/- to
change
channel use up/down to
change
bit rate, use +/- button to
change
Caution
15