User's Manual

03-D/R/EXPO

●Function description

Both this two functions are to set 2 different value and use specific switch to activate. DR is using on

Aileron elevator and rudder's control ratio, the bigger the ration, the greater the action. The greater action is

suitable for maneuver. Smaller action is suitable for those with precise requirements. This function normally

being adjusted after EPA setting with largest travel distance.

Parameter setting is through the change of the curve and parameters, to allow different sensitivity of the

control stick during the center point and the end point. Default value 0 means they have the

same sensitivity,

the greater the value is, the sensitive on the end point and thus the more precise the action is and Vice versa

●Setting method

1, Select DR 03 under setting mode

2, press UP/DOWN select DR 1/2/3/4/ setting or EXPO 1/2/3/4/setting.

3, press +/- to adjust the ratio, switch

D/R 1/2 to choose switch position.

4, press and hold Menu to exit or press menu to switch to next item.

120%

100%

60%

Output default output soft output sensitivity

Helicopter

Y output

X stick position

X stick

position

X stick position

X stick

position

X stick position

X stick

position

Default EPA biggest EPA EPA in small range