User's Manual

06- HOLD Throttle hold

07 CUT throttle cut

●Function description:

During landing, use throttle hold function to fix the throttle at a low level. The range of the throttle normally

set between -75% to +75%. For safety reason, when tuning the plane or helicopter on the ground, the throttle

POS need to be set to -75%, and hold the

throttle, to avoid any mis-operation.

●Setting method:

When the setting active, use +/- button change INH (inhibit) into ON/OFF. Under this situation, when the

switch pushes to ON or OFF, the screen will display accordingly.

1, select HOLD 06 under setting mode

2, press +/- button to change status, press UP/DOWN button

to set the throttle position (POS).

3, press and hold Menu to exit or press menu to switch to next item.

●Function description

Throttle cut means after flying to turn off the engine. It is controlled by a switch. Active this function and the

engine will stop running when the switch

turns on.

●Setting method

1. select CUT 07 under setting mode

2. press +/- to adjust the status, push up/down button to set the position POS and RATE.

3. Press and hold Menu to exit or press menu to switch to next item.

Helicopter