User's Manual

08 Time (timer)
09 N TH (Normal throttle curve)
●Function description:
Timer is to allow the transmitter to alarm before your plane or helicopter exhaust the power.
The largest setting is 99 minutes and 59 seconds
Control method: timer ON/OFF, Throttle upper limit, throttle lower limit.
Setting, TM to set minutes, TS for second, SW for switch control, THR↑for throttle upper
limit, THR↓ for
throttle lower limit. POS for throttle position.
When timer reach 0, will beep for notification. If you don't turn off the timer, then it will beep every minutes.
●Setting method:
1, select TIME 08 under setting mode
2, press UP/DOWN select position, press +/- to change value
3, Press and hold Menu to exit or press menu to switch to next item.
●Function description:
Throttle curve is a curve with 5 editable points. It divided the throttle control into 5 areas. The editable value
range for the points is from 0 to 100%. In default situation 5 points can reach the
throttle ration as shown on
picture 1. picture 2 is change the fifth point to 80%, when the stick in the range of 4/5 to 5/5. throttle raising
slowly and the max value is 80%.
Through the adjustment of the throttle curve, can optimize the stick position with the engine output. The
adjustment of the throttle curve need to be adjusted together with the pitch curve (refer to NPI section) which
allows the main RPM of the rotor can be maintained with the control stick moving.
●Setting method
1, select N TH 09 under setting mode
2, Press UP/DOWN to choose position,
press +/- to change value
3, Press and hold Menu to exit or press menu to switch to next item.
1 2 3 4 51 2 3 4 5
0% 25% 50
%
75% 100%
0% 25
% 50%
75% 80%
Helicopter
19