User's Manual

(17). START OFS
This function is used to offset the aileron, elevator, and flap servos
to the position that provides maximum lift during launch. Normally
the ailerons and flaps are drooped about 20-30, with the flaps drooped
slightly more to prevent tip-stailing on tow. The elevator can also be
offset in oo
trim out any pitch changes caused by the flap and aileron
presets.
Setting Method:
Use up/down button to select START OFS, OK button is to
enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to set value. Press OK button for seconds can
back default.
3.
Press EXIT after setting.
INSTRUCTION
GLIDER
155