User's Manual

6. SUB TRIM
Sub trim makes small changes or corrections to the neutral
position of each servo. Range is -120 to +120, default setting
is 0.
Setting Method:
Use up or down button to select SUB TRIM, OK button is to
enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/-
button or OK button to set the trim value. Press OK
for a while backs to default.
3. Press EXIT after setting.
We recommend that you center the digital trims before making
Sub trim changes, and that you tryto keep all of the Sub trim
values as small as possible.
Otherwise, when the Sub trims
are large values, the servo’s range of travel is restricted on
one side.
Channel
Value
High/Low
INSTRUCTION
GLIDER
137