User's Manual

8. TRIM STEP SETTING
This function is to change the rate at which the trim moves
when the TRIM LEVER is activated. The range is from 1to
250. Generally larger trim steps are for models with larger
control throws or for first flights to ensure sufficient trim to
properly correct the model. Smaller trim
steps are later used
to allow very fine adjustments in flight.
Setting Method:
Use up/down button to select TRIM STEP SETTING, OK button
is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to adjust the size of the step. Repeat as desired
for other
channels. If you select RESET, the current channel trim
value change to 0.
3. Press EXIT after setting.
INSTRUCTION
GLIDER
139