User's Manual

22
The Installation Method Of Receiver
Do not trim or bundling antenna.
Note: due to the fact that the receiver would send out the hot air, please install in a well
ventilated place when installing in order to avoid overheating.
Please use the foam to pack receiver and thick version of double-sided adhesive tape fixed to
achieve the shock effect.
If there is moisture, please send receiver into waterproof plastic bags, to achieve waterproof
effect.
Please try to make the receiver stay away from battery, electronic speed controller, motor or
metal wiring and other noise sources.
The antenna is sheathed in the pipe to protect it.
The antenna is installed in a higher position.
Don't bend coaxial cable, which may cause damage.
X4 must be used under the following conditions:
The receiver battery : 3.7~6V
6V
Ni/Cd
Digital Servo Simulation Servo / Digital Servo
The transmitter steering response mode is normal mode: simulation servo (6V 50Hz) /
digital servo (6V 270Hz).
The transmitter steering response model is the high speed mode: digital servo (6V 270Hz).
Terms Of Use
Careful