User's Manual

26
The Preparation Before The Transmitter Sets
Set The Function Of Transmitter, Please Confirm And Set The Following ①~④ Items.
Turn on the power, the main interface will display the model number of the currently
selected, if you need to change, please use the model selection (see page 51).
Turn the power switch to the "PWR ON" , RF can be normally output signal,
the blue indicate the light is bright
Turn the power switch to the "DISP ON" end, RF does not output signal,
the red indicate the light is bright.
When using the high speed mode, please use the digital servos.
When using the normal mode, please use the analog / digital servo actuator.
Servo Type Confirmation
2
The throttle trigger, set the throttle and steering action value to 5:5 or 7:3.
Please read the < throttle mode > (thirty-fifth pages).
Throttle Mode Confirm
3
Initial Set-up
The Rf Signal Output Validation
1
Model Name
Model No.
Timer
Channel Monitor
Battery Voltage
Fine Tune Monitor
AT \DR MonitorL
Terms Of Use