User's Manual

English
1. Installing the battery and charging
• Switch the unlock key on the battery chamber lid to “
”, and then push the battery
chamber lid towards the mark “OPEN”. Vertically place the battery in the battery chamber,
and close the battery chamber lid.
• Please use a standard adapter and data cable to connect to the charging port to charge
the gimbal. During charging, the red indicator will flash slowly. When charging is
completed, the red indicator will remain lit.
2. Installing the gimbal
• Properly insert the gimbal into the clamping ring of the gimbal, and then rotate the gimbal
clamping ring in the direction as indicated by the arrow.
• To remove the gimbal, first rotate the gimbal clamping ring, and then pull the gimbal out.
3. Mobile device bracket
• Point the bracket nut to the disk gear and tighten the nut, and then rotate the adjustable
bracket.
• Adjust the adjustable bracket to fix the mobile device, and rotate mobile device bracket
to a proper angle.
4. Installing the memory card and switching on the gimbal
• When the gimbal is switched off, insert the memory card into the TF card slot. When a
“click” is heard, the card is installed properly.
• Press and hold the power key for three seconds to switch on the gimbal, and then the
red indicator will remain lit.
Note: It is recommended that you use a TF card that is U3 rated or faster, so as to shoot
videos smoothly.