4} Connect the receiver to a monitor TV with AV cable (yellow for dives ang red for audio}. Turn on the monitor TV and select AY mode. 5) Connect the power jack of adapter {DC 7. 5V 300mA)} to receiver. Crass the Power QR/OFF button and the channel! indicator fights up green.
§) Press the Channel Select Button "CH" on the receiver until the channel! indicator match the channel on fis corresponding camera frequency. The monitor/TV wil display the camera image. 5 i pr Chapati Sahel Button "CH 7} Adjust the brightness, contrast and color of the monitor TV to perfection.
Camera installation 1. Locals whets you would like to winnable the camera and give it a quick tacit to ensure the chosen location has perfect receptions. Pl sass follow the steps blow te install the camera to a wall or ceiling. 1.1 Secure the three screw anchors into wall {or calling) to match the hole patter of the camera bracket 1.2 Align tha holes of the camera bracket with the anchors, and secure the caners fo the wall with three screws 2. Adjust the angle 2.
Eight Vision The built-in Infra-red lights in cameras provide 7m night vision range for 24s surveillance. The Infra-red lights will automatically be activated at night or in dark places. The picture will turn Black & White (monochrome) in Night Vision mods Receiver Mode Setup Tha receiver can support up to 2 cameras. Only one camera will display on screen at a time. There are two methods to toggle between cameras, either by manually control or auto-loop control.
Receiver Channel Setup 1 ON: CHI Enable Defect) OFF: CH Dissemble 2ou: SHE Enable Actual) OFF: CH Disable The channel Mode Control are used to tun the camera(s) OFF or ON depending on the number of active camera in use. If the CH is set to the OFF position, the Manual Mode and the Chan's! Scan Mode will not take into affect.
1. Manual mode: Slide Made Contra! switch to M 1 enter Manual mode. In this mode, the receiver channel will not change until the Chanson Soloist Button "CH™ Is press. Note: To manually toggle between channels, It requires two active camera. 2. Shanna! Scan mode: Slide Bede Control switch to L io enter channel scan mode. in this mode, all the available channels will display one by one looping in tum every § seconds.