User's Manual

Find Reversing Power
How to use the detector to find the power from the reverse
power?
1 Step on the reverse gear.
2 Clip the pincers to the metal of the car body.
3 Use the red pen to find the power by thrusting
into the tape. Make sure the penpoint touch the wire core.
4 If the LED light is on, find out the light wires.
5 Push the switch to the parking and use the red
pen to detect it, if the light turns off, then the wire is the
reverse power.
6 Connect the reverse power wire with the red
wire of the camera and tie them together with the electronic
tape.
LCD Installation
1 Before permanently mounting the monitor,
please clean the mounting place. And let it dry thoroughly.
Stick the monitor bracket bottom with double tape face
and press firmly to adhere tightly.
2 Press the monitor bracket firmly onto the area
you just cleaned. Adhesive reaches maximum strength in 24
hours. Moving the fastener from its original position will
weaken the adhesive and may damage the mounting surface.
3 Adjust the angle for perfect viewing effect.
4 Connect the power jack to the monitor and
connect the black pin of the power jack with the black pin of
the prolong cable. (Refer to Find Anode +12V section on
Page10)