User's Manual

ESP-32S User Manual

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

Please notice that if the FCC identification number is not visible when the module is installed inside another

device, then the outside of the device into which the module is installed must also display a label referring to

the enclosed module. This exterior label can use wording such as the following: “Contains FCC ID:

2AHMR-ESP32S” any similar wording that expresses the same meaning may be used.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a minimum distance of 20cmbetween the radiator & your

body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

The module is limited to OEM installation ONLY.

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or

install module.

The module is limited to installation in mobile application;

A separate approval is required for all other operating configurations, including portable configurations with

respect to Part 2.1093 and difference antenna configurations.

There is requirement that the grantee provide guidance to the host manufacturer for compliance with Part

15B requirements.