User's Manual

IPCAM User manual
Mask: The default subnet mask of the equipment is: 255.255.255.0
Gateway: Make sure it is in the same subnet with PC IP address .Default
Gateway address is 192.168.0.1
DNS: IP address of IPS network provider.
Port: LAN port assigned for the equipment, usually 80
User & Password: Default administrator username/password: admin. No
password
Enable Using DHCP the system will assign a reasonable IP address for your
equipment. Only if your gateway supports DHCP (It is the case with most
gateways).
NOTE: When the prompt “subnet doesn’t match, double click to change!” please
set the IP Camera IP address once again.
 Upgrade Firmware
Enter the correct User and Password to upgrade system Firmware and Web UI.
 Refresh Camera List
Refresh camera list manually.
 Flush Arp Buffer
When cable network and wireless network of the device are fixed IP
address .There is a problem you may encounter is can search the camera IP but
can’t open the camera web page .you may try to use Flush Arp Buffer.
2.2 Camera Login
You can access the camera through IP Camera Tool or IE directly.
1) Double click the IP address of the IP Camera listed (Figure 2.1).
2) To access the camera ,start your web browser and type in the camera’s IP
address
—8—