User's Manual

IPCAM User manual
1 Sensitive Hole
2 Infrared LED
3 LENS CMOS sensor with fixed focus lens.
4 Antenna
1.3.2 Rear panel
Figure 1.2
LAN: RJ-45/10-100 Base T
DC5V: 5V Power supply
RESET BUTTON: press and hold down the RESET BUTTON for 15
Seconds .Release the power button and IP Camera will be reset back to the factory
default Parameter.
1.4 PC System Requirements
System configuration requirements :( Example for view four IP Camera)
CPU: 2.06GHZ or above Memory: 256M or above
Network Card: 10M or above Display Card:64M or above memory
Recommendable Operating system: Window2000 or Window XP or Vista
1.5 Hardware Instruction
Follow the steps below to set up your camera hardware. Make sure to follow each
step carefully to ensure that the camera operates properly
1) Plug the network cable into the camera and then into your Cable/DSL router.
Plug the power adapter into the camera and then into the power outlet.
—3—