User's Manual

FUNCTIONS FOR CONTROL SET
Mode 2(left hand throttle)
Throttle Max
Elevator down
Rudder
left
Aileron
left
Rudder
right
Aileron
right
Elevator upThrottle Min
Ch2 ( ) Trim adjustmentelevator
Power switch
Reverse switch on CH4(rudder)
Reverse switch on CH3(throttle)
Reverse switch on CH2(elevator)
Reverse switch on CH1(aileron)
Ch1 (aileron) Trim adjustment
Ch3 ( ) Trim adjustmentthrottle
Ch4 (rudder) Trim adjustment
ADJUST THE SPEED OF THE ROTOR BLADES BY THE PCB BOARD
Power wire
* Motor 1
* Sevor 2
* Motor 2
* Sevor 1
1.Funtion of knob: adjust the gesture of the helicopter by adjusting the speed of upper and lower rotor blades.
(1) If you turn the knob clockwise, the speed of the downward rotor blade will increase and helicopter will turn
right.
(2) If you turn the knob widdershins, the speed of the upper rotor blade will increase and helicopter will turn left.
2.PCB is well adjusted before shipment, so the end-customer need not adjust it.
www.art-tech.com
8
LED Indicator
* Please refer to the page 13 for the position of servos and motor
Rotor blade speed
difference adjust
knob