User's Manual

Table Of Contents

Adjustmen order

Charge method of battery

Charge method：

1.Turn off the transmitter, connect the transmitter with the charger in the kits

(Note: Please make sure the transmitter be off before charging, It will not charged unless it is off)

2.check it the input voltage is same as the main voltage,

the plug the charger into the socket.

3.the charging time should be no more than 5 hours,

it should be recharged if it has been unused in long time.

Remark:

1. only the 9.6V Ni-He rechargeable battery can be

charged, the dry cell should not be charged.

2 order to prolong the life of battery, please do not

charge more than the required time.

Open the battery bay, and range the 8 cells AAA battery

into the battery bay, then close the bay.Before adjustment,

change the reverse switch to the lower positon(Nor). Open

the transmitterand the receiver, and do the following steps:

1.check every servo`s movement and make sure every movement of control arms and servo arms is

correct If not, please change the switch for reverse.

2.Check the centering position of ailoren,elevator and rudder

Open the transmitte r an d conne ct t h epower to motor. Make sure every servo is in cetering positon

and check servo armh as a 9 0 a ngel w ith servo. Adjust the length of controll rod, and check all control

arm is in neutral position.

3.Adjustment for range

Check the movement range and the centering positon of each servo. If the travelling range is not accepted,

that can be adjusted by the position of clevise on the servo arm.

4.Check the connection of ESC and Motor

Check the joystick for throttle movement is in accordance with motor. If not, it is can be adjusted by

reverse switch.

5.Check the tiny mix for every control horn.