User's Manual

Table Of Contents

Explaination for Technical words

CH1 CH2

CH2 CH1

120°

Front

Here are some technical words used in this Manual

Aileron:Either of two movable flaps on the wings of an airplane that can be used to control

the plane's rolling and banking movements

Elevator:A movable control surface, usually attached to the horizontal stabilizer of an aircraft,

that is used to produce motion up or down.

Rudder:A similar structure at the tail of an aircraft, used for effecting horizontal changes

in course.

Throttle:A valve that regulates the flow of a fluid, such as the valve in an internal-combustion

engine that controls the amount of vaporized fuel entering the cylinders.(For

electronic plane, it can adjust the currency)

Channel:that means the quantity of isolated operation,and also can indicate the number of servos

Joystick: a stick that can be used to control operation on the transmitter

Proportional Radio:the servo is controlled by that radio and th e serv o arm s ca n mo ve

proportionally and this kind of radio can be called proportional radio

Modulation Mode:Usually there are two modulation mode in radio controll system: AM and FM.

Normall y FM i s chose d fo r mode l plane.A s wel l, ther e ar e tw o mod e i n signa l

code communication:PPM and PCM

Neutral:Without operation, joysticks in the center position and the servo arm will come to center.

Control Horn: a pole that can connect the servo and control set.

Servo Arm: a part of servo,and it can transit the servo movement to the control horn.With many

shpaes, and it should be fixed to the servo by screw.

V tail mixer:

see the following figure

Connect the elevator

Connect the aileron

Triang wing mixer:

see the following figure

Connect the aileron

Connect the elevator

CH6 CH1

CH2

CCPM Mode: The helicopter pitch is controlled by three servos combined

Aileron Action: Servos for CH1 and CH 6 move in opposite direction synchronously,

and the inclined tray set moves rightward and leftward

Elevator Action: Three servos move in same space, the inclined tray set move

backward and frontward.

Pitch Action: Three servos move in the same direction synchronously, and the

inclined tray set moves upward and downward horizontally