User's Manual

www.art-tech.com

5.mixing settings (A, V, D mode)

6. Other function of the transmitter

Press the menu button, enter into the Mix menu (mixing).There are 2 sets of

mixing settings.

5.1 Mixing setting:

1. Press the sub button; enter into the Mix1 menu (mixing 1).

2. Press the Left or right button, choose the right option (whether to use

or not, the master channel, the slave channel, mixing proportion).

3. 1) Whether or not to use option: press y / up or n / down button to confirm

(YES) or cancel (NO).

2) Master channel option (Mas): press y / up or n / down button to select

the master channel.

3) Slave channel option (Slv): press y / up or n / down button to select the

slave channel.

4) Mixing proportion setting: y / up or n / down button to set the mixing

proportion. The slave channel is under control of the master channel at

the setting proportion. (The value may be set anywhere between 0% and

100%) Reasonable settings of MIX make flight of delta-wing or V-tail aircraft

which need the two-channel mixing control easy.

5.2 Mixing setting:

1. Press the sub button; enter into the Mix2 menu (mixing 2,3,4).

2. Specific settings are the same as Mix1.

Press the menu button; enter into the Pls menu (plus function).

6.1 Channel Display and Calibration:

1. Press the sub button, enter into the Chv menu (view of channels).

2. Press the Left or right button, choose a channel, the channel output

trip is displayed.

6.2.1 To restore the factory settings:

1. Press the sub button; enter into the Bak menu (back to original set).

2. Press the y / up or n / down button to confirm or cancel restore the

factory settings. Press the y / up button to confirm the resumption of the

factory settings.

6.2.2 Calibrate Settings:

Use at the first flight or the aircraft is changed) Press the y / up button, place

the sticks in the normal locations (Throttle channel minimum, other channels

middle), press the n / down button to confirm. (In this calibration process,

output values of all channels is the initial values)

1. Press the left or right button and enter the calibrate menu (calibrate Settings).

2. (

100%),press the y / up or n / down button to increase or reduce the value.

The values set take effect when the 3D switch is switched on. The value

may be set anywhere between 0% and 100%)