User's Manual

Function of Transmitter

ETC62D-2.4GHz is a newly developed 6 channel proportional transmitter. The latest developed

product of ART-TECH RC Hobby Corporation. The 2.4GHz RC system uses digital frequency-hopping

technology; it has enormous advantage compared with traditional system: no crystal, no frequency

interference, short antenna length and low power consumption.

1. Flying time display: less than 1 minute seconds showed, more than 1 minute minutes showed.

2. Supply voltage display and low voltage alarm function: When the battery voltage is lower than 8.5V,

the red LED flashes, and alarm.

3. Channel output reverse set.

4. 5 kinds of aircraft modes to choose， 12 independent aircraft data storage and call.

5. Mode I and mode II exchange.

6. Throttle protection: in order to avoid danger of starting the motor of a

sudden, when throttle hold switch is turned on, throttle output value is the

minimum.

When boot, for various reasons (location of the assembly, curve setup),

throttle output value is not the minimum, the red LED flashes and alarm, as

shown in the figure. The throttle lose automatically locked out for a

minimum value, when the transmitter adjustment is appropriate (that is, the

throttle output is the smallest), the transmitter is unlocked.

7. Ch1 ch2 ch4 DR (Dual Rate) setting.

8. Ch1 ch2 ch4 EXP(exponential curve) setting.

9. All channel EPA (end of the process) setting.

10. Ch5 two-state setting (gyroscope sensitivity setting for helicopters, landing gear set up for fixed-

wing planes).

11. Ch3 ch6 general and 3D mode curve set for general helicopters and CCPM helicopters

12. 4 groups channel mixing control

13. All channel output dynamic display

14. All channel mid-point regulation

15. Restore the factory settings

16. Ch1 ~ Ch6 auxiliary fine-tuning settings

www.art-tech.com

Thanks for purchasing ETC62D-2.4GHz radio control set. For safe use, please read

this manual before using carefully. Any damage or loss to radio control set and model

due to inproper use will not be shouldered by Art-Tech.